SCDL Production and Operations Management Paper - 54

This solved paper of SCDL Production and Operations Management of SCDL Pune has been contributed by XYZ

 Thanks To: XYZ

 

 

Multiple Choice Single Answer
Question	MRP is based on the concept of inventory demand which is of following type
Answer	Dependent and independent
Multiple Choice Single Answer
Question	Main objective of a good plant layout is
Answer	Reduce material handling cost
True/False
Question	As a general rule, the number of tail event of an activity is more than that of it's head event.
Answer	FALSE
Select The Blank
Question	The ________ is the probability that a good lot will be rejected by the sampling plan.
Answer	Producer's risk
Multiple Choice Multiple Answer
Question	Which of the following are important considerations concerning activity times?
Answer	Activity time should be obtained from the person responsible for the completion of an activity , Activity time must be independent of any influence which the preceding or succeeding activity may have on it. , Activity time may assume that just the normal quantity of resources required to carry out the activity are available.
Select The Blank
Question	The ________ pertain to the climatic conditions which the component , product or material should withstand.
Answer	Environmental specifications
Multiple Choice Multiple Answer
Question	Following are some of the factors considered for evaluation of alternative layouts
Answer	Flow of Material , Equipment utilization , Ease of supervision
Multiple Choice Multiple Answer
Question	Which of the following are assignable cause?
Answer	Large varaitions in hardness of material , Tool wear , Errors in setting
True/False
Question	All activities must not be tied up into the network
Answer	FALSE
Select The Blank
Question	In case of an OC curve, the risk of rejecting a good quality lot may vary between ________.
Answer	0.01 to 10%
True/False
Question	In case of X bar, if the process is not under control indicated by some points falling outside the control limits, such points outside the control limits are eliminated and new trial control limits for the remaining points are computed.
Answer	TRUE
Multiple Choice Single Answer
Question	What is the base for considering activity time as single time estimate or three time estimate?
Answer	Level of uncertainty
Select The Blank
Question	The ________ is the maximum percentage defective that for the purpose of sampling inspection can be considered satisfactory as a process average.
Answer	Acceptable quality level
Multiple Choice Single Answer
Question	What do you mean by lowest possible direct cost required to complete an activity within it's normal time?
Answer	Normal cost
Select The Blank
Question	A good maintenance system is not a luxary but a ________.
Answer	Necessity
Select The Blank
Question	A ________helps to avoid crowding of jobs at a particular machine by change of route of some of the jobs or by diverting work to other machine.
Answer	Control board
Select The Blank
Question	The ________ is the watch dog which ensures that every element of production and activities which could affect the quality of end product are regulated to the extent desirable.
Answer	Quality control
Multiple Choice Single Answer
Question	Any premise in which persons are employed for purpose of making any product/s is called
Answer	Factory

 

 

Note: Please tally the answers and verify them from SCDL text books as all answers might not be correct.